3. The conveyor belt conveyor belt repair damaged parts and semi-cured surface strip belt brushing glue dry for a conveyor Which would be good, and then the second time brushing (dry set to sticky conveyor belt which until Dongguan good home, at room temperature, usually in the case of five minutes). 4. Place the patch attached to the conveyor belt sanding strip straightened surface compaction were beating Which Foshan conveyor with a rubber mallet or compaction rollers, driven out of the air. Tips: If the ambient temperature is too low recommends using halogen lamps or hot air gun heating 0.5-1 hours, allow appropriate time if prolonged heating Humen conveyor Which is good, will help to improve the strength of the adhesive surface. 4. Use a heat curing or vulcanizing machine repair pressure, heat curing. Tips: vulcanizing machine controller temperature control between 145-150 ℃, until the upper and lower curing temperatures are stable and good board to start curing time of 35 to 45 minutes. (According to the thickness of the belt, each plate curing every 4 minutes approximately 1mm vulcanized rubber) to be vulcanized plate temperature drops below 70 ℃ before curing machine hydraulic lift and remove the vulcanizing machine. Which is good, Shenzhen conveyor belt conveyor belt _ _ Which hose provided by Yichang South Africa South Africa hose tape Limited. Yichang South Africa hose tape Limited (www.znjgjd.com) strong, credible, Yichang, Hubei Province in other industries has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead South Africa into the brilliant hose and you work for a better future!