High pressure hose from the die, jackets, rubber layer and the layer of wires and other components. High pressure hose used hydraulic support more use of each aircraft stand of approximately 10--30 roots, therefore manufacturers braided hose, high pressure hose structure and connection method to use will directly affect the stability of the stent. The use of high pressure hoses requirements are as follows: (1) Before use, check type, length meets the requirements, and do the sampling pressure test, qualified before use. (2) Check fittings and hose connections or without bare wires, the outer layer if there is separation, industrial dryer if this phenomenon can not be used. (3) connecting the ends of the pipe joint coating shall have dislodged, fall off may not be used, to avoid Mifengbuyan produce leakage. (4) to deal with the inner wall of the hose to clean newly installed, in order to avoid gum powder and debris into the hydraulic system. High pressure hose connection requirements are as follows: (1) should be connected to prevent hose torsion angle is changed so as to avoid skeleton layer and destroy it early. (2) the length of the hose should leave a margin for action against pulling hose length changes caused by lower pressure capability when connected. (3) Fixed hose clamps should be placed on the curve and straight line intersection, the clip can not deform the south end of the hose braided hose card manufacturers, card can not be too loose. (4) connecting the moving parts, should allow sufficient length so as not to strain during exercise hose. (5) bend radius connections shall comply with the relevant provisions. 1, the core components: through a liquid booster pump to pressurize the liquid in order to test pressure requirements. 2, pneumatic two pieces together: for compressed air filter and regulator; 3, the control valve: adjust the drive air flow to adjust the operating frequency of the turbocharger Dongfeng braided hose manufacturer, to extend the life of the turbocharger; 4, high-pressure filter: filter for gas treatment; 5, high pressure limiting valve: Set supercharger automatically shut down and turn on the pressure to ensure that the turbocharger will automatically stop when the set pressure. 1, the core components: through a liquid booster pump to pressurize the liquid in order to test pressure requirements. 2, pneumatic two pieces together: for compressed air filter and regulator; 3, the control valve: adjust the drive air flow Xiaolan braided hose manufacturers to adjust the operating frequency of the supercharger, turbocharger prolong life; 4, high-pressure filter: filter for gas treatment; 5, high pressure limiting valve: Set supercharger automatically shut down and turn on the pressure to ensure that the turbocharger will automatically stop when the set pressure. Braided hose manufacturers, SOUTH hose, braided hose manufacturer Dongfeng provided by Yichang SOUTH hose tape Limited. Braided hose manufacturers, SOUTH hose, braided hose manufacturer Dongfeng Yichang SOUTH hose tape Limited (www.znjgjd.com) (www.1234.com) this year introduced a new upgrade, the above picture is for reference only, please dial this page Phone or pictures on obtain the latest information, contact: Mr. Xu.